- Provides a continuous source of warmth, primarily from cheap off peak electricity.
- Convector gives completely silent top-up heating.
- Convector thermostat can be set to maintain constant room temperatures and automatically switch on as necessary.
- Automatic charge regulator, which automatically adjusts the level of input charge to compensate for changing weather conditions without user intervention.
- Conveniently positioned convector controls on the front panel.
- Lower convector loadings selectable on installation.
- Secure wall fixing for safety.
- Feet may be fitted under carpet or on top of suitable floor covering.
- Simple assembly for flexible positioning and quick installation.
Internal Details – Storage Heater
1 Storage Core : Material: High density bonded magnetite bricks.
2 Heating Element : Type: Incoloy sheathed in units of 850W.
3 Thermal Insulation :
Type (a) Front and Rear Panels – microporous silica.
Type (b) Top and Ends – resin free mineral wool.
Type (c) Base – calcium silicate slab.
4 Supply Connection : Located at front right hand end of base – accessible by removal of front panel assembly. Hidden cable support straps at rear of heater allow neat supply cable connection from either side of heater.
5 Assembly : Remove front panel assembly then front inner skin. Remove internal packing containing elements, position rear layer of bricks, heating elements, and front layer of bricks.
Storage Controls : The control knobs are positioned on the sloping rear top panel of the heater, and are therefore out of sight of young children. The knobs incorporate a cross bar and raised pointer for ease of operation.
1 Charge Controller : Type: Hydraulic close differential room temperature sensing thermostat with external sensor.
2 Thermal Safety Device : Type: Bi-metal – manual reset.
3 Damper Control : Type: Bi-metal strip, selection variable from early to late or zero boost.
Convector Controls : Located to right of convector air outlet grille.
1 Room Temperature Thermostat : Type: Hydraulic, adjustable.
2 Safety Cut-Out : Type: Bi-metallic, disconnect supply to reset type.
3 ON/OFF Switch : Type: Single pole incorporating neon which illuminates when switch is in ON position.
4 Neon : An additional neon illuminates when convector heater is drawing current.
Willow White top, sides and front panel. Contrasting Birch Grey grille, rear heat shield and wall spacer.
Galvanised finish sheet steel base, mounted on steel feet, supporting double skin front and outer panels. One piece front panel/grille assembly and front inner skin remove for brick loading.
1 Case Assembly and Weights
Containing assembled heater case and heating elements. Packed in single carton.
|Model||Weight without bricks||Weight with bricks||No. of bricks|
2 Storage Bricks
Supplied, 2 bricks per pack. Approx brickweight 7.5kg each. (See above for weight of heater with and without bricks).
Shelf : An attractive shelf is available in 3 lengths.
Internal Details – Convector Heater
Type: Stitched Ribbon.
2 Supply Connection
Located at front left end of heater base. Cable entry at left hand end. Cable support straps at rear of heater allows neat supply connection from either side of heater.
† When using Dimplex shelves a clearance of 150mm must be maintained. The wall fixing arrangement is adjustable to accommodate for skirtings up to 150mm high and 25mm deep.
|Storage Heater performanceInput Rating||1.7kW||2.55kW||3.4k|
|Charge Acceptance 7hr||11.9kWh||17.85kWh||23.8kWh|
|Convector Heater performance / Maximum Output||900W||1450W||2000W|
|Other outputs available(Set on installation)*||450W||450W, 1000W||650W, 1350W|
|Height above floor||88mm||88mm||88mm|
* Element can be de-rated by 50% on installation.